Heavy Duty Magnetic Flywheel Rotor Replacement Kit For 375 400 LTA400 Sled And ATV Fires Up Your Whip Instantly Ensures Solid Ignition Timing And Smooth Trail Cruising Ride All Season Long
✔️ Single cast steel block routes clean wiring straight to your CDI module
Replace tired ignition components to get your trail sled or utility quad spinning reliably again. This direct install upgrade swaps out faulty rotors to restore crisp throttle response and steady charging across weekend mud rides or mountain trails.
✅ Engineered cast housing locks tight to crankshaft mounts without drilling✅ Copper wound terminals transfer voltage cleanly to CDI pickups
✅ Exact dimensional geometry guarantees proper air gap clearance
✅ Reinforced bobbin insulation shields internal wires from road grime
💡 How often should you swap a weak induction ring on vintage sled platforms?
Trading out a degraded magnetic flywheel is a handy setup move that brings your original spark timing back to spec without touching the wiring harness.
- Low flux density makes electric pulls drag and headlight glow fade quick
- Fresh rotors snap right onto legacy cranksnouts to keep amps steady
- Tight tolerances kill coil chatter so full throttle hits clean every turn
- Heavy duty epoxy seals copper leads against dust and spray during deep washes