Heavy Duty Coreless Digital Servo Delivers Rock Solid 45kg Torque Through Premium Steel Metal Gear High Octane RC Motor With Snappy 180 To 360 Degree Turning And Beast Grade Dual Ball Bearings For Serious Hobby Mods

Digital RC Servo Featuring Metal Gears and High Torque Capacity
✔️ Single unit build with steel gears, dual ball bearings, 300mm wire

This compact actuator is built for serious radio control projects, locking down precise steering angles while keeping heat down during extended runs. Most drivers install it inside modified off-road rigs where thick tires and heavy bumpers demand a motor that refuses to fade. Each purchase comes with one ready-to-drop-in unit that drops straight into standard receiver harnesses with zero extra wiring work.

✅ Operating voltage window spans five to eight point four volts for wide receiver compatibility

✅ Steel reduction train maintains steadfast forty-five kilogram hold power under heavy drag

✅ Housing footprint clocks in at forty by twenty by forty-one millimeters for confined dash mounts

✅ Paired bearing layout absorbs lateral shock to protect the main drive shaft from premature wear

✅ Three hundred millimeter JR plug cable reaches cleanly to controller boards without extra splicing

💡 Why swap out basic analog units for heavy duty digital steering motors on modified chassis?

- Coreless coil design fires up quick to give you handy throttle mapping when carving through tight hairpin corners

- Tough steel gear combos refuse to strip when you're wrestling heavy axles through sloppy mud and loose washboard dirt

- Reinforced bearing cages lock geometry tight under side load so your toe settings never walk out mid-run

- Standard connector plugs slide straight into your receiver for zero fuss swaps whenever you need fresh parts on site