6mm Wide Timing Belt for RepRap Delta 3D Printers Including Kossel Rostock Open End, 1 Meter Length, 2mm Pitch, Fiberglass Rubber Construction, Black Single Sided Drive Belt for Smooth Motion, High Durability and Quiet Operation

2mm-pitch timing belt for delta printers, 6mm wide
✔️ 6mm wide, 2mm pitch, 1m length, fiberglass rubber, black

This timing belt is designed for delta-style 3D printers, including RepRap Delta, Rostock, and Kossel configurations. It is a single-sided belt made of fiberglass-reinforced rubber, in black, with a 2 mm pitch and 6 mm width. The 1 m length fits open-end installation on standard delta frames.

✅ Width 6 mm (0.24 in), pitch 2 mm (0.079 in), length 1 m (39.37 in)
✅ Material: fiberglass-reinforced rubber, single-sided, black
✅ Open-end length compatible with delta printer towers (Rostock, Kossel)
✅ Pack size: 1 belt per order (1 m)

💡 What is a GT2 timing belt used for in 3D printer assemblies?

It's a handy drive belt that translates motor turns into precise linear motion.

- 2 mm pitch design for precise belt engagement and smooth travel - 6 mm width handles standard loads with low deflection - 1 m length fits common delta configurations with open-end setups