DC Motor Control KBMM-125 With 115 VAC Input And 0 To 75 HP Range, 90 VDC ARM, Plug-In Horsepower Resistor Required, Line Fuse Provision, Mounting Options For Industrial Use
✔️ 50:1 speed range, 90 VDC ARM, requires plug-in horsepower resistor
The KBMM-125 is a full-wave DC motor control built for industrial use, driving PM and Shunt motors from 1/100 to 3/4 HP (1.5 HP with an auxiliary heat sink). It runs on 115 VAC input and provides 90 VDC ARM drive. A plug-in horsepower resistor must be installed (sold separately). It also has provisions for mounting plug-in line fuses and armature fuses (fuses sold separately).
✅ 115 VAC input and 90 VDC ARM output
✅ 1/100 to 3/4 HP control range (1.5 HP with aux heat sink)
✅ Requires plug-in horsepower resistor (sold separately)
✅ Provisions for mounting plug-in line fuses (fuses sold separately)
✅ Provisions for mounting armature fuses (fuses sold separately)
✅ 50:1 speed range and 1% load regulation
✅ Auto Inhibit, Voltage Following, MOV transient protection
✅ 5K speed pot plus trims for Min, Max, Accel, Decel, IR, CL
✅ Optional accessories: heat sink, barrier terminal board, RFI/EMI filters, SI-6 isolation
💡 How to pick a DC motor controller for industrial 115 VAC setups? This handy guide covers practical factors for selecting a drive.
- 115 VAC input compatibility with PM and Shunt motors - 90 VDC ARM output and appropriate HP range - plug-in horsepower resistor requirement - fuse mounting provisions and safety certifications (UL, CSA, CE) ✝️