Compact Dc Holding Electromagnet With 24 Volts And M3 Female Thread Delivers A Tough 5 Point 5 Lb Grip For Robotics And Industrial Setup Featuring Instant Lockup And Zero Residual Magnetism For Reliable Daily Operation
✔️ 24v dc rating m3 thread 20x15mm body 2.5kg pull force
This single pack dc holding magnet locks onto steel plates within milliseconds using a 24 volt power source. Engineers typically mount this compact actuator inside automation jigs precision pick and place units and custom grippers that demand clean power off release.
✅Pulls down 2.5 kg or 5.5 lbs on flat steel plates 6 mm or 0.24 inch thick minimum✅Measures 20 mm or 0.79 inches across and 15 mm or 0.59 inches tall overall
✅Mounts via m3 internal thread tapped straight through the solid back face
✅Drains residual charge instantly when voltage cuts to prevent sticky retention errors
✅Runs safely at constant load while keeping housing temperature below 120 c or 248 f
✅Requires direct contact with conductive metal spanning the full 20 mm or 0.79 inch diameter footprint
💡What guarantees a solid magnetic hold releases fast during automated picking routines?
These handy dc actuators drain their coil completely so you never wrestle with ghost grips or bent sheets. Straightforward design keeps your rig rolling smooth.
- Stick to copper windings rated for continuous duty cycles without overheating your controller
- Match the rated pull weight to your heaviest clamp load plus a safety margin for smooth moves
- Verify zero residual ratings keep nearby sensors from tripping false signals after power loss
- Mount straight onto flat steel plates to get maximum contact area and consistent grip strength