Rear Manual Transmission Motor Mount For 2007 Chevrolet Cobalt A5374 Direct Fit Replacement Beefy Rubber Constructed Component Cuts Driver Shakes And Keeps The Chassis Tightly Bonded Over Rough Roads

Sturdy Rear Manual Transmission Mount For 2007 Cobalt Auto
✔️ A5374 direct fit rear mount supports manual drivetrain vibration

This rubber built A5374 component slots right into your drivetrain tray to deaden shift shock and stop frame rattles. You drop it under the chassis to anchor the transaxle while eating up bumps around town or down the highway.

✅ Part number listed as A5374 comes in a single piece pack
✅ Engine size runs 2.2L L4 or 2.4L L4 configurations
✅ Built for left side rear placement under the cab
✅ Direct bolt swap matches factory bracket layout and holes
✅ Rubber durometer designed to kill torque twist and harshness

💡 How do folks swap a tired transmission crossmember to fix gear clunk?
You get a handy setup when you pair the right rubber hardness with solid steel tabs.
- Align the cast iron bracket to your chassis rails before torquing the nuts
- Tighten the lower hardware in small steps to keep the shaft centered straight
- Press fresh mounts into place to banish that nasty driveline lash and rumble

✝️