Badass 2Pcs Set Ribbon Fiber Splicer Clamp Replacement For Fujikura FSM-90R FSM-88R FSM-70R FSM-70R 8Core 900Um Sheath Chuck Holder Jig Beat The Rest With Nailed It Precision And Zero Stress For Your Daily Grind Quest Essential Upgrade Rock Solid
UPC:
✔️ FH-70-900 clamp secures eight 900um ribbon strands during splice
This replacement chuck assembly is built to hold eight core 900 micron ribbon fiber cables steady inside popular fusion splicing machines. Field techs pop these clamping jigs into FSM-70R FSM-88R FSM-90R and FSM-70R+ encoders to keep the plastic jacket locked in place while the electric arc melts the glass tips together for a low loss joint.
✅ Model FH-70-900 engineered for 900 micron ribbon jacket thickness ✅ Grips exactly eight cores per strand for precise lateral alignment ✅ Direct drop-in swap for FSM-70R FSM-88R FSM-90R and 70R+ units ✅ Ships as one pair or two piece set ready for immediate depot use💡 What routine checks should technicians perform before loading new replacement splicer chucks?
Swapping holding fixtures on your fusion gear keeps splice yields high and cuts downtime down handy. Just run through these quick setup steps to avoid alignment headaches.
- Inspect the rubber gripping pads inside the clamp slots for dust or debris before seating the plastic housing
- Slide the new chuck fully into the fiber guide rail until the detent clicks and locks flush with the frame
- Trigger an empty motor cycle to verify the drive belt pulls the ribbon straight without lateral wobble
- Load your prepared cable assembly and close the lid tightly to maintain constant pressure throughout the heat cycle