6 Pack Oilless Bushing Sleeve Bearings 0.87 Inch Bore X 0.98 Inch Outside Diameter 1.18 Inch Long Copper Bronze Plain Bearings Made Tough On The Job With No Hassle Maintenance And Sweet Rolling Action For Workshop Gear

Get 6-Pack 22mm Sintered Bronze Self-Lube Sleeve Bearings
✔️ 22 mm Bore 0.87 inch, 25 mm OD 0.98 inch, 30 mm Len 1.18 inch.

These 6-piece oilless bushing sleeve bearings utilize corrosion-resistant copper bronze over a carbon steel base to deliver steady sliding action without grease. This pack supports general-purpose tasks in textile machines, hydraulic loaders, and fitness rigs where you need dependable wear reduction and vibration dampening over long service intervals.

✅ 6 pcs copper bronze wrapped bushings with carbon steel backing for robust mounting strength
✅ 22 mm inner diameter fits 0.87 inch shafts while keeping friction factors between 0.04 and 0.2 for smooth rotation
✅ 25 mm outer diameter measures 0.98 inch across to secure housing placement in tight assemblies
✅ 30 mm long body offers 1.18 inch bearing length covering full load area along the axis
✅ Solid friction design operates effectively under wide temperature ranges during continuous sliding movements
✅ Self-lubricating surface eliminates grease dependency and minimizes noise for quiet operation on shop tools
✅ Resists corrosion and wear while isolating shafts from special media to extend component lifespan
✅ Replace worn original bushings directly or reduce bore diameter to restore fit without machining

💡 What improves longevity when installing bronze sleeve bearings in high-load environments?
Your assembly lasts longer and stays handy when you follow these key steps for proper pillow block bushing setup.
- Ensure the shaft diameter matches the 0.87 inch bore tolerance to prevent uneven stress distribution during torque spikes
- Verify the housing press fits tightly around the 0.98 inch outer diameter to maintain proper clearance alignment
- Keep surfaces clean from debris before insertion since trapped particles accelerate wear in dry friction sliding zones
- Apply light initial run-in lubrication only if required by your specific machine type though these bushes handle dry operation well

✝️✝️