4 Inch Setback Jack Plate For Outboard Motors Up To 35HP With Wooden Mounting Block Included, Adjustable Distance Between Engine And Transom, A Beefy Ready To Go Upgrade For Skiffs, Aluminum Boats, And Inflatable Boats, Easy Clamp On Mount

4-Inch Setback Outboard Jack Plate with Wood Block - Single
✔️ Extends 4 inches off transom; supports up to 35 HP with wood block

This 4-inch setback jack plate is built for clamp-on outboard motors up to 35 HP. It uses a cast aluminum offset design to mount long shaft motors on shorter transoms. The kit includes a pre-cut wooden mounting block for a secure, reliable fit and easier installation.

✅ 4" setback from transom to improve engine height and boat handling
✅ Engine mounting surface: 11-1/2" wide x 10" high; transom flange width 17"
✅ Max weight capacity: 150 lbs; Max HP: 35 HP
✅ Cast aluminum construction with wooden mounting block included (Model WOOD0002)
✅ Easy installation thanks to clearly marked hole positions and simple drilling

💡 What is a jack plate used for in small boats?

A jack plate adjusts motor height and setback to optimize trim, planing, and propeller efficiency on small craft.

- Improves propeller bite and trim with increased mounting height
- Lets you run longer shaft motors on shorter transoms
- Improves handling and planning, especially on lightweight skiffs
- Supports clamp-on outboard motors up to 35 HP with a sturdy wooden mounting block