Workhorse Automatic Steel Bar Circle Bending Machine Electric Rebar Bender Built To Knock Out One Point Two Six Inch Carbon Steel Rods Smooth As Silk Rated 220V 4kW Setup
✔️ 220V 4kW Motor, 1.26in Max Bend, Foot Pedal Control, Yellow
This compact automatic steel bar circle bending machine handles heavy round metal rods for commercial build sites. Crews use it daily to shape reinforcement loops for concrete slabs, erect rail bridge supports, and frame utility pole footings. Load a carbon steel rod up to 32 mm or 1.26 inches, hit the foot switch, and the 4 kW drive spins out clean circles in under fifteen seconds. A sturdy yellow chassis rolls on grip pads for easy repositioning, while top lifting eyes keep crane moves secure. Wire it straight to a short circuit protector to skip messy cords.
✅ Form pure carbon steel rods up to 32 mm or 1.26 inches wide✅ Process grade II threaded bars up to 28 mm or 1.10 inches thick
✅ Hold loop radii down to 300 mm or 11.81 inches minimum
✅ Turn out complete bends in six to twelve seconds flat
✅ Pull steady current from 220 volt mains via hard wired setup
✅ Save wrist strain thanks to convenient foot operated pedals
💡 Why pick a motor drive steel bar circle bending machine for tough site tasks?
Operators prefer this electric setup because it takes the heavy lifting out of repetitive hoop forming.
- This arrangement stays remarkably handy when you need to churn out matched ring sets fast without blowing out your joints.
- Hard wired motor banks bypass loose cord messes and deliver uninterrupted torque straight to the bending shaft.
- Locked arc geometry guarantees identical diameters across massive foundation grids without constant measuring checks.
- Low center base rides on cushioned casters to glide across dirt floors while soaking up vibration during runs.