Water Pipe Heat Tape For Metal And Plastic Pipes, No Fuss Install, Prevent Freezing With Self Regulating Heat Trace Cable, CSA And ETL Certified, All Weather Protection, 3 Ft Length, 7 Watts Per Foot, 120 Volt
✔️ 3 ft length - 7 W/ft - 120 V - CSA/ETL certified - pre-assembled
This self-regulating heat tape is a ready-to-install solution designed to prevent freezing in water-filled plastic (including PEX) or metal pipes. It comes with a grounded plug, an indicator light, and a built-in thermostat for easy setup. Operates at 120V, 7W/ft, with an automatic thermostat turning on at 37°F and off at 50°F. Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. No crossing, spiraling, or overlapping; install straight only.
✅ 3 ft length heat trace cable (single length)
✅ 7 watts per foot heat output
✅ 120 volt operation
✅ CSA and ETL certified from end to end
✅ Grounded plug with indicator light and built-in thermostat
✅ Automatic thermostat on at 37°F, off at 50°F
✅ Uses up to 1/2 in fiberglass insulation for lower temperature protection
✅ Must be installed straight (no crossing, spiraling, or overlapping)
✅ Backed by USD 2 million product liability insurance
✅ Test before installation to verify safe operation in an ice bucket
💡 What is a typical use case for self-regulating heat tape on water pipes?
It's a handy solution that helps prevent freezing by warming only the sections that need heat.
- Auto-adjusts heat output based on ambient temperature
- Suitable for water-filled plastic (including PEX) or metal pipes
- CSA and ETL certified safety with built-in thermostat
- Pre-assembled with grounded plug and indicator light for easy setup