VPS-123 Cast Iron Pillow Block Ball Bearing Two Bolt Setscrew Lock With Contact And Flinger Seals Fits 1-7/16 Inch Bore, 1-7/8 Base To Center Height, Hardcore Build With Hella Durability And Smooth Roll For Machines

Single Pack Cast Iron Pillow Block Bearing
✔️ 1.4375 shaft bore with setscrew lock plus flinger seals

This two bolt pillow block bearing arrives ready to mount on industrial setups. You drop it onto factory conveyors or farm harvesters to kill wobble before damaging expensive belts. The solid housing takes punishment from misaligned shafts, and the external fins sweep off sticky residue fast.

✅ Precision 1.4375 inch shaft capacity for tight fit alignment
✅ Heavy cast iron housing resists impact drops and frame stress
✅ Setscrew mounting system secures firmly against vibrating drives
✅ Flunger shield pairs with contact seals to block grit entry

💡 How do you mount a cast iron pillow block bearing correctly?

Handy installation steps keep your equipment turning smooth through long runs. Follow these straightforward guidelines for reliable performance.

- Choose a shaft fit that slides in without hammering force - Snug the hex setscrew until firm stopping point hits metal - Level the mounting bolts so side forces never pry the seal gap - Run periodic grease packs to flush out road dust and grit✝️