Universal Hydraulic Gear Puller And Bearing Separators With Two Or Three Jaw Configurations Extracts 33000 Pounds Without Breaking A Sweat For Vertical Or Horizontal Tasks

Industrial strength hydraulic bearing extractor
✔️ 15 ton pull, 2 inch stroke, 360 degree arm, matches standard industrial shafts

This heavy duty hydraulic gear puller kit removes stubborn bearings, pulleys, and hub assemblies from vehicles and machinery without damaging components. Mechanics and auto technicians rely on it for quick jobs in shop bays, garages, and mobile repair setups where power tools fall short.

✅ 15 ton load capacity built to move 33000 pounds effortlessly during axle work
✅ 2 inch (50 mm) piston travel reaches deep into tight engine compartments quickly
✅ Pulling arms extend 11.8 inches (300 mm) wide with a 7 inch (180 mm) vertical reach
✅ Thick cast steel body handles repeated pump cycles without flexing or leaking fluid
✅ Swappable two finger or three jaw heads snap on fast for different shaft profiles

💡 How do independent mechanics remove seized pillow block bearings from drive shafts fast?
Using a sturdy hydraulic press layout keeps things simple and saves back strain during tough pulls.
- Center the main ram directly over the shaft axis to spread load evenly across mounting plates
- Pump the handle in smooth cycles to advance the pulling threads without jerking heavy components
- Inspect cylinder seals regularly to maintain peak fluid pressure throughout extended shop maintenance jobs