Tough Three Roll Hydraulic Metal Bender That Knocks Out Flat Stock And Square Tubes Without A Sweat Featuring Quick Horizontal Vertical Switching And Serious Three Horsepower Rolling Power

Professional Hydraulic Metal Rolling Bender
✔️ 3HP drive forms flat stock square tube and round bars to 50 mm

This HRBM-50HV hydraulic roll bending machine shapes steel aluminum and stainless profiles using a reliable electric-hydraulic drive. You will find this setup running smooth jobs in metal fabrication shops automotive repair HVAC work and railing manufacturing where consistent curves matter.

P ✅ 2.2 kW hydraulic pump delivers steady torque for heavy gauge stock
✅ 50 mm 1.97 inch diameter rollers run at 10.8 rpm spindle speeds
✅ Flat bar profile accepts up to 60 by 10 mm (2.4 by 0.4 inch) material
✅ Square tube max loads reach 50 by 50 by 3 mm (2 by 2 by 0.12 inch)
✅ Round bar capacity tops off at 35 mm (1.4 inch) diameter cuts
✅ Rectangular sections take up to 50 by 40 by 4.5 mm (2 by 1.6 by 0.18 inch)
✅ Reversible foot pedal and emergency cutoff boost shop floor safety

💡 What makes a hydraulic metal roller handy for tackling mild steel and aluminum tube?

- Electric-hydraulic pumps kick out steady torque through dense stock without bogging down on heavy runs. - Adjustable pressure lets you dial in smooth radii clean and fast so delicate metals stay damage-free. - Swap between horizontal and vertical setups quick to tackle long structural bars or tight curve racks. - Reversible foot pedal and cutoff switch give you total command so your hands stay clear of pinch zones.✝️