Tough As Nails Heavy Duty 30 Ton Hydraulic Gear Puller With Adjustable Two Or Three Jaw Setup For Yanking Stubborn Wheel Bearings Straight From Your Home Garage Today
✔️ 30 ton capacity, 15.7in pull, 400mm side reach, alloy jigs
This hydraulic gear puller works as a heavy duty bearing separator and shaft extractor built for home garages, diy driveline repairs, and light machine shop chores. You can swap the tongs into a two or three arm layout depending on the part, flip the pump cylinder to run face up or on its side, and yank stubborn wheel hubs, crank pulleys, and pressed bushings straight off without scoring the metal.
✅ 30 ton lifting capacity, 22 kg weight total✅ 15.7 inches or 400mm lateral slide range
✅ 9.8 inches or 250mm longitudinal pull depth
✅ 2.95 inches or 75mm axial piston stroke travel
✅ 3.5 inch screw thread paired with 4.1 inch base spread
💡 How does a heavy duty hydraulic gear puller simplify difficult axle removal?
Applying steady fluid pressure beats hammering and peening parts every single time. Mechanics call this handy method legit for tight workspace clearance.
- High lift cylinders chew through rust faster than manual wrenches
- Sliding base plates clamp solid to flat frames without walking around
- Bleeder knobs drop pressure instantly so oiled gaskets stay intact