Straight Up Tough Self Stick Insulation Pins 2-1/2 Inch With Galvanized Finish And Self Locking Washers Plus Dome Caps For Zero Hassle Foam Board Wall Floor And Ceiling Setup

Pack of 100 Sets Self Adhesive Insulation Pins For Walls
✔️ Galvanized steel shaft with aluminum dome cover and tight locking washer

These rugged insulation anchor pins come in handy for quickly fastening foam boards, fiberglass mats, and duct wrap straight to floors, walls, and ceilings. The self sticky adhesive base drops onto clean plaster or concrete surfaces so you can skip messy glues while keeping thermal layers locked in place during basement finishes or attic upgrades. Each delivery arrives as one hundred complete sets containing three hundred mounting pieces total.

✅ Includes one hundred complete pin assemblies totaling three hundred separate mounting hardware pieces
✅ Features a two and a half inch long galvanized steel shaft rated for steady load holding capacity
✅ Uses mild steel self locking rings to grip insulation panels tight without slipping or pulling loose
✅ Tops off with rounded aluminum covers that hide sharp steel points and protect against accidental scrapes

💡 What handy solution do contractors grab for taping down rigid foam sheets over concrete floors without heavy adhesives?

Setting up a self adhesive insulation pin kit takes the guesswork out of thermal layer mounting and saves labor hours.

- Galvanized steel cores resist moisture exposure while providing steady pull strength on damp crawlspaces - Mild steel locking collars clench down firmly on varying foam thicknesses for consistent hold - Aluminum dome lids trap air gaps snugly while stopping dust buildup around fastener heads
✝️