Straight Shooter 1/4 Inch Brad Point Boring Bit 10mm Shank Carbide Tipped For Nailed Tight Dowel And Pin Holes Featuring A Driving Flat And Adjustable Screw For Top Shelf Woodworking Precision That Always Delivers
✔️ 6.35mm tip, 35mm cut depth, 10mm shank, single unit sold
This single pack holds one right handed bore bit built for punching clean blind holes straight into lumber. The 6.35 mm (0.25 in) edge and 35 mm (1.38 in) reach make it mighty handy for seating dowels, pins, or anchor screws deep inside solid wood without splintering the face. The drive flat pairs with any standard chuck setup while the adjustable collar locks your plunge depth for repeatable cuts.
✅ 6.35 mm (0.25 in) cutting diameter scores tight joinery paths✅ 35 mm (1.38 in) maximum plunge range handles deep hardware spots
✅ 10 mm (0.39 in) cylindrical shaft mates with standard press chucks
💡 What actually separates a handy brad point drill from a standard twist bit? Snagging the right profile drops the tearout when you are tackling hidden fastener jobs. You will run smoother and save headaches when you kick back with this handy gear for rough framing or fine shop work. - sharp center spur locks onto fresh fibers instantly while side spurs carve the ring - wide flutes yank chips fast so the steel never boils over on oak or maple - blunt nosed design prevents wandering so you can punch dead centered cores
✝️