Spal 30102044 Puller Cooling Fan 13 Inch High Performance Curved Blade Electric Axial Blower For Vehicle Engine Radiator HVAC Car Bus Systems 40 Amp Fuse Compatible Ultimate Airflow Solution

13 Inch Curved Blade Fan Single Pack For Engine Radiators
✔️ Puller axial blower mounts behind core runs 13v DC systems

This electric axial blower comes as a single pack ready to bolt onto universal radiator cores for performance street rods or commercial buses. You ditch the old serpentine drive setup and route direct power to move massive volumes of air straight through the condenser stack. It works perfectly in tight engine bays where clearance favors rear mounted cooling solutions.

✅ 13 inch curved diameter pulls steady airflow
✅ Brushless dc motor delivers quiet torque over time
✅ Universal mounting holes adapt to most aftermarket grilles
✅ Requires a 40 amp inline fuse for stable 13 volt feed

💡 How does mounting an electric axial blower behind the radiator improve cooling efficiency?

- Puller configuration sucks hot air raw out the backside of the fin stack to dump thermal mass quick - Killing the belt drive leaves your crank free spinning for actual track gains and keeps the bay neat - Dropping a 40 amp fuse in line saves the brushless guts from nasty startup spikes on shaky 12volt wiring - Slipping in some hard rubber spacers locks the curved shell so it stays dead silent over potholes ✝️