Slick Built To Last Self Aligning Pillow Block Bearing For 10mm Shafts With 2 Bolt Flange Mount Zinc Alloy Housing And Chrome Steel Insert Set Screw Locking Pre Lubricated For Smooth Quiet Operation And Longer Wear
✔️ Precision-machined for 10mm shafts, self-aligning housing tilt 2°
Designed for 10mm shafts, this self-aligning pillow block bearing provides smooth, quiet operation in CNC machines, 3D printers, conveyors, and other automation equipment. Its die-cast zinc alloy housing stays light yet tough and resists rust in damp workshop environments. Inside, a chrome steel insert with double seals keeps grease in and dust out, while a built-in grease fitting lets you relubricate without disassembly.
✅ 10mm shaft compatibility for secure mounting✅ Die-cast zinc alloy housing keeps weight down and resists corrosion
✅ Chrome steel insert with double seals for reliable lubrication
✅ Factory pre-lubricated with a relubrication point for quick maintenance
✅ Two set screws at 120° lock the shaft during load and start-stop cycles
✅ 2-hole slotted flange with 7mm mounting holes and 56mm center-to-center spacing
💡 What is a pillow block bearing used for in motion systems and automation? Pillow block bearings provide shaft support and alignment for rotating assemblies, helping reduce wear and improve stability. - Handy for CNC machines, 3D printers, conveyors - Compensates mounting misalignment up to a few degrees with the self-aligning housing - Sealed chrome steel insert with pre-lubrication for low maintenance
✝️