Rugged Zinc Chest Handle 3.5 Inch Cabinet Pull for Cabinets, Drawers, and Tool Boxes, Heavy Duty Zinc Alloy Construction, Smooth Finish, Easy Install, Fits Most Standard Openings, Long-Lasting Hardware

Heavy duty zinc cabinet pull for drawers and chests
✔️ 3.5 inch spacing, solid zinc alloy body, smooth plated finish

This sturdy chest handle works great for upgrading kitchen cabinets, workshop drawers, and metal storage units where reliable grip matters. The curved bow design gives you a solid hold, while the included mounting hardware makes swapping it out without hassle.

✅ Center-to-center distance measures 3.5 inches
✅ Overall dimensions are 0.19 by 0.31 by 0.46 inches
✅ Zinc plated exterior blocks rust and daily wear
✅ Solid alloy steel core supports frequent heavy use
✅ Weighs roughly 0.34 pounds for secure shelf mounting

💡 What are the best practices for mounting a standard cabinet pull on hardwood cabinetry?
This handy installation routine keeps your drawer hardware secure and ready for years of grab-and-pull action. You mainly need to align the pre drilled mounting points correctly before tightening the fasteners.
- Use a tape measure to mark exact drilling spots for consistent spacing
- Pre drill pilot holes slightly smaller than the included screw diameter
- Hand tighten the provided fasteners until the pull sits flush against the surface
- Test the grip and adjust alignment if the bow feels uneven during daily opening