Pro Grade 1/2 Inch Emt To 3/8 Flexible Metal Conduit Connector With Set Screw And Dual Clamped Grip Die Cast Zinc Housing For Dead Nuts Secure Wire Runs Smooth Burnished Finish Heavy Duty Gear

Pack Of 100 Heavy Duty 1/2 In Emt To 3/8 Fmc Kit
✔️ Die cast zinc body dual clamp grip set screw secure lock

This bulk pack of one hundred fittings bridges rigid metal conduit to flexible wiring runs straight into breaker panel cutouts and junction box mounts. Electricians rely on these sturdy adapters to guide copper or aluminum conductors out of solid raceways without snagging or stressing the insulation.

✅ Half inch trade size EMT mates cleanly to three eighth inch flexible metal conduit
✅ Seven eighths inch maximum housing width fits standard knockout grids
✅ Solid die cast zinc alloy shell reinforced with a heavy gauge steel strap
✅ Integrated set screw works alongside dual clamped grips for zero slip holds
✅ Mirror smooth burnished surface wipes clean and protects cable jackets
✅ Ready to drop into service as a standard case of one hundred pieces

💡 How should you torque an emt fmc connector to stop conductor chafing over long pulls? Locking the fitting correctly preserves current flow and keeps maintenance crews safe. A handy habit is to wedge the tubing deep until the internal liner stops rolling, then work the hardware symmetrically so pressure spreads across the metal wall. Build reliability into every joint by following these steps: - seat the conduit firmly against the rear shoulder before touching any bolts - advance both side clamps equally until the steel band flattens completely - thread the set screw just past the point of initial bite so it rides smooth