Premium Steel Heavy Duty 10 Mm Ball Stud Mounting Brackets For Gas Struts With 10 Hex Nuts Knockout Quality No Sweat Assembly Top Shelf Guarantee For Garage Swaps
✔️ Heavy duty galvanized steel gas spring mounts with 10 mounting screws
This kit supplies a set of four ball stud mounting plates designed specifically for attaching 10 mm connector gas springs to truck tails, tool chests, and shed doors. You get two flat round plates alongside two angled long plates, which gives you the flexibility to match almost any hinge angle without wrestling with misaligned hardware. These brackets are a solid choice for garage swaps or backyard builds where steady lift support matters.
✅ Package includes two flat round and two angled long steel mounting brackets ✅ Comes with ten heavy duty hex nuts and matching machine screws for quick hookup ✅ Zinc coated finish resists rust and bending while handling tough daily loads ✅ Adjustable hole placement makes it simple to tweak alignment during setup💡 How do standardized bolt pattern brackets improve gas strut longevity?
Securing lift mechanisms with properly matched mounting hardware cuts down on early wear and tear.
- Heavy duty steel plates spread pressure evenly across weak cabinet corners or thin truck beds
- Pre threaded nut sets eliminate guesswork while keeping rattling bolts from ruining your setup
- These handy units tackle rough outdoor conditions without needing constant tightening or replacement
- Direct compatible fit with common linear slide systems locks in smooth operation year after year