Premium Kicking M18 Bonded Sealing Washers Heat Pressed Carbon Steel with Nitrile Rubber Gasket Stops Leaks Boss Level Burst Resistance Heavy Duty Pack of 5 Fits Plumbing Jobs Like A Glove
Heavy Duty M18 Bonded Seal Washers For High Pressure Systems
✔️ Set Of 5 Seals - 18mm Id - 24.5mm Od - 2Mm Thick - M18 Thread
You rely on these sealed washers to plug stubborn leaks on busy shop floors.
Each unit locks a tough steel ring to a soft rubber pad so grime never wins.
Mechanics run them through hydraulic, pneumatic, and plumbing rigs to squash fluid waste.
Toss five units in your kit because they drop straight onto your next haul.
✅ Measures twenty four point five millimeter outside diameter against eighteen millimeter opening
✅ Holds sixty a hardness ranking while surviving minus twenty to one hundred degree heat swings
✅ Self centering design skips special part shaping and speeds up every single install
✅ Built to handle severe pipe stress without the common blow out issues found elsewhere
💡 What makes bonded seals the handy pick for grinding shop floor leaks?
These sealed components take the sweat out of tightening stubborn bolts on wet machinery.
- The heat fused rubber clings tight to the steel face even when pumps kick harder
- Squeezed geometry pins the gasket flat to shut down diesel drip and compressed air bursts
- Standard metric thread fits drop right into existing tool kits without extra buying runs