Premium Heavy Duty Stainless Steel Chimney Support Bracket Kit For Pellet Stoves And Water Heater Vents All Weather Roof Brace Featuring Straight Forward Installation And Rock Solid 4.75 Inch Pipe Mounts You Can Lean On Any Day
✔️ Adjustable stainless support leg extends 120 cm max
This heavy duty chimney support bracket kit secures pellet stove flues wood heater exhaust pipes and outdoor roof vents against wind and snow. Designed for straightforward wall floor or roof mounting it keeps plumbing and drainage systems stable while resisting rust in wet climates. Each pack comes ready to fasten directly to solid surfaces.
✅ Stainless tube resists rust and cranks tight from seventy-nine millimeters up to two hundred fifty-four millimeters wide✅ Height adapter reaches forty-seven point two inches or one hundred twenty centimeters total extension
✅ Support arm clamps securely to any round flue measuring three point one to ten inches across
✅ Mounting screws seal tight to wood or concrete frames for quick setup in under ten minutes
💡 What steps stop a chimney support leg from loosening on a sloped roof?
You can keep your venting rig tight without breaking a sweat by sticking to some handy job site habits.
- Anchor the mounting plate straight into solid wood studs or concrete before bolting anything down
- Slide the height rod until it hits your desired level then spin the wing nut till the pipe sits dead center
- Slather waterproof caulk around every fastener to shut out rain while letting fumes blow freely outside
- Give the clamp knobs a quick check after major cold snaps so nothing rattles loose during high gusts