One Inch Bore Two Bolt Flange Mount Pillow Block Ball Bearing Housing With Rock Solid Cast Iron Construction Secure Setscrew Lock And Beefed Up Reliability For Heavy Industrial Workloads
One single 1 inch two bolt flange pillow block bearing unit
✔️ 1 inch bore deep groove ball insert cast iron block
You are getting a single mounted bearing unit built for moderate industrial shaft loads.
This rigid mount drops straight onto flat metal frames so you can back up conveyor shafts, fan hubs, or blower arms without fancy weldments.
The sturdy design holds tight while letting you slide or remove the housing during routine service.
✅ Double-contact rub seals keep factory grease locked tight against dust
✅ Hex sockets on opposing rings clamp the shaft firmly without distortion
✅ Oil zerk port sits right on the face for quick greasing under load
💡 Why do heavy machine shops prefer pillow block bearings for motor mounts?
A handy bearing frame takes the guesswork out of your daily floor work. You get straight talk about shaft support that cuts down on downtime. These mounts hold their ground while letting you slide them into place fast. Check how they actually run when under pressure:
- Cast iron housings swallow vibration before it reaches sensitive drive components
- Tightly packed rubber lips trap fresh grease inside so you avoid messy topping off
- Tight set screws bite into solid metal shafts so nothing slips backwards
- Rounded bearing walls auto correct small angles so machines run dead smooth