No Sweat Plastic Featherboard For Table Saws Router Tables And Band Saws Non Marking Hold Down Tool That Locks Boards Tight So You Can Crank Out Perfect Cuts
✔️ High-strength polymer construction secures lumber tightly for cutting
Sold as a single unit, this plastic featherboard works as a handy hold down fixture on stationary saws and router benches to keep flat stock pressed hard against the guide rail during rough pass-through jobs.
✅ Advanced tip geometry avoids deep gouges on fragile project surfaces✅ Integrated ruler markings speed up repeatable setup times easily
✅ Wide chamfer notch slides fast on completed pieces as a layout marker
✅ Bend-resistant tines maintain constant push pressure regardless of grain
💡 What distance between mounting holes does a featherboard need to fit varying router table layouts? These handy metal-to-plastic fixtures clamp real tight to bench faces to curb nasty kickbacks and keep your knuckles clear of spinning chisels and milling heads. - Pre-drilled base holes align instantly with standard T-slot tracks found on most cabinet mills - Reinforced mounting tabs resist strip-out forces when torquing hex bolts during aggressive pass-through runs - Interchangeable spacer blocks shift tine spacing precisely to accommodate sheet goods wider than twenty-four inches
✝️