No Sweat Hydraulic Gear Puller Kit With Swappable Two Or Three Jaw Design For Knocking Stiff Hubs Brake Drums And Flanges Loose Under Heavy Loads

Sturdy Hydraulic Bearing Puller Kit For Stubborn Hubs
✔️ 2in(5cm) stroke, 7.8in(20cm) reach, forged alloy puller frame

This heavy duty puller kit tackles stuck hubs, brake drums, pulleys and gears under serious load. You can run it flat on a shop floor or straight up in tight engine bays without stressing the internal seals or bending pins.

✅ One piece cast pump body stands up to constant cranking without cracking ✅ Switch between two and three jaw positions to grip odd shaped shafts ✅ Hardened alloy hooks bite deep and hold firm during maximum draw weight ✅ Pump head spins full circle so you can grab leverage from any working angle ✅ 2in(50mm) throw matches tight clears while 7.8in(200mm) max span handles large assemblies

💡 What sets a proper hydraulic bearing separator apart from manual slide hammers? Relying on steady fluid pressure instead of impact forces protects delicate housing threads and keeps everything perfectly centered throughout the extraction phase. You want predictable force delivery and a solid anchor point to avoid slipping mid cycle. - Seat the foot plates wide against the target edge before pushing the handle - Keep the center nose flush against the inner race to distribute pull evenly - Pump in short controlled bursts rather than slamming the lever all the way down - Retract fully and reset grips before attacking stubbornly pinned components

✝️