Killer 12 Inch 36V 500W Brushless Hub Motor Rear Wheel Conversion Kit With Pneumatic Tire And Disc Brake For Electric Scooters Custom Ev Builds And Mountain Bikes Built Tough Ridin Ready

36V Brushless Hub Motor Wheel Kit For E Scooter Upgrades
✔️ 500W 36V BLDC Motor 12 Inch Pneumatic Tire Disc Mount Hall Sensor

This single rear wheel conversion kit pairs a durable 36 volt brushless motor with a ready to mount rim and road rubber. Builders swap these on electric scooters and small frame cycles to skip manual motor fitting. You get direct drop in mounting for fork axles alongside a prewired sensor harness that plugs straight into your existing 36v speed controller. The pneumatic casing absorbs pavement chatter better than solid plastic options.

✅ 36V 500W brushless drivetrain system
✅ 12.5 by 2.25 inch 317 by 57 mm pneumatic tire plus tube
✅ Built in disc brake rotor mounting flange
✅ M14 axle thread with 10mm shaft diameter 0.39 inch center bore
✅ Color coded hall sensor wiring harness set
✅ Assembled wheel profile measuring 320mm by 12.6 inch height and 212mm width

💡 What makes a direct drive hub setup handy for electric scooter conversions versus traditional belt motors? Swapping to a fixed gear arrangement removes chain slack tracking and sprocket alignment headaches. - Eliminates continuous tension adjustments during frame fabricating work - Keeps power transfer steady without skipping under heavier rider loads uphill - Cuts down on moving part friction while extending service intervals outboard

✝️