Kickass Adjustable Dust Collection Rig For Split Bed Wood Lathes With Tight Four Inch Hose Hookup And Three Way Flex Brackets For Hassle Free Woodworking Cleanup

Single Pack Lathe Dust Collection System With Flex Arms
✔️ Cast Aluminum Gate, Snug Mount Set, 4 Inch Hose, Blue Finish

This single dust collection rig is built for split bed wood lathes where precise chip capture matters more than flashy features. Shop owners bolt the sliding base directly onto machine rails to trap flying sawdust near the rotation plane while leaving plenty of clearance for wide turning blanks. The compact housing pairs smoothly with mainstream cyclones or blowers that push roughly fifteen hundred cubic feet per minute through standard ductwork.

✅ Custom fit mounting kit with stainless steel hardware for secure installation
✅ Heavy duty cast aluminum blast valve opens fully for fast internal cleaning
✅ Quick release snap hook keeps four inch vacuum hose locked in place under vibration
✅ Three axis pivot arms let you angle airflow up down or side to side
✅ Powder coated blue housing resists woodshop moisture and routine contact damage

💡 What diameter hose connection works best with a heavy duty split bed lathe dust collector?

Nailing the perfect airflow match depends on pairing the correct duct size to your motor rating while leaving room for quick adjustments during active shaping. Keep the following handy routing tips in mind when wiring up your cleanup station. - Stick to four inch rigid tubing to prevent static buildup and maintain consistent velocity near the cutting zone - Route the flex bracket assembly along the rear rail so gravity pulls falling shavings straight into the intake path - Swap to a two and a half inch adapter only if you are running a portable shop vac rated below twelve hundred CFM - Install the disassembleable valve near the main run to isolate blocksage without shutting down your entire vacuum system

✝️