IntXanth 70.87 Inch Acrylic Plastic Heat Bending Machine, 2000W Strip Heater for PVC And Organic Boards, Professional Bender For Zero To Six Mm Sign Making And Decoration Projects

Complete Single Unit 70 Inch Acrylic Strip Heater
✔️ 2000W hot bender, 180cm wide zone bends zero to six mm acrylic sheets

This acrylic plastic bending machine is a compact strip heater designed to soften thermoplastic sheets for custom sign making and display crafting. The single pack arrives fully wired so operators can mount it directly to workbenches for quick layouts on plexiglass, PVC, and organic boards. The unit applies steady heat across its full 1800 mm or 70.87 inch span so fabricators can curve panels into precise shapes for light boxes, retail displays, and decorative projects.

✅ 110V input paired with two thousand watt output for rapid warm up times
✅ Maximum bending width measures seventy point eight seven inches or 1800 mm edge to edge
✅ Working thickness stays within zero point two four inches up to six millimeters flat
✅ Sealed aluminum housing resists warping while protecting internal wiring from heat damage

💡 How do you get consistent curves on a heavy duty acrylic hot bending unit? Cracking the code on smooth bends comes down to matching feed speed with correct thermal exposure. This handy tool takes the guesswork out of shaping thermoplastics because you can trust these proven practices: - Dial in the thermostat near two hundred ten degrees celsius for solid three millimeter or 0.12 inch cuts - Slide the stock straight through the center so the heating wire warms both sides evenly - Bend while the sheet feels pliable like warm chewing gum to avoid sticky stress marks - Swap in backup glass tubes anytime the current set shows wear to keep your line running tight

✝️