High Torque 14Kg Metal Gear RC Servo Motor Tailored For 1/10 Scale RC Drift Cars With 180 Degree Travel And Premium Red Aluminum Build Delivering Hella Smooth Digital Control At 4V To 6V

Heavy duty metal gear rc servo for accurate drifting chassis
✔️ single unit features 14kg torque plus 180 angle and 40x20x29mm frame

This single digital steering actuator bolts straight into fourteen scale radio controlled platforms. You normally install it in the front subframe to handle sharp cornering forces when carving asphalt drift layouts.

✅ Delivers fourteen kilogram centimeters of pulling power up to six volts input
✅ Cuts cornering lag with a tight four microsecond dead zone across full motion sweep
✅ Mounts cleanly into standard three pin signal headers inside compact racing chassis
✅ Features a soft launch routine that keeps initial current draw low on the ESC

💡 Why swap an original plastic steering box for a heavy duty metal geared digital unit?

Dropping in a solid transmission assembly makes your ride totally handy for weekend canyon runs.

- Rugged alloy cogs chew up curb abuse while keeping steering response sharp out on the street

- Integrated timing control prevents sudden power spikes so your receiver board lasts longer

- Precise gearing minimizes play so turning becomes instant and absolutely dope

- Flexible voltage range accepts any standard battery pack without overheating the internals

✝️