Hella Tough Solid Brass 1/4 Inch Hose Barb Y Connector Three Way Barbed Fitting With Clamps Built Strong For Racing Fuel Oil And Pneumatic Tubing Systems
Solid Brass 1/4 In Y Barb Tee Joints For Fuel & Air Lines
✔️ 1/4 in brass Y barb tee holds 350 PSI and comes with three hose clamps
This handy single connector pack delivers one main tee valve plus three matching hose clamps for instant mounting. You slap it right onto air compressor racks and brewery tanks. It saves you from rummaging through toolboxes hunting for mismatched adapters.
✅ Thick brass body shrugs off brutal shop heat reaching five hundred degrees Fahrenheit✅ Tapered barbs clamp down tight on quarter inch tubing and refuse to slip under heavy shop air loads
✅ Ships pre packed with one Y manifold and three snap type metal clamps
✅ Channels clean pneumatics, light motor oil, and cleaning solvent through tight frame rails
💡 Why trust a cast brass Y tube joint for tough garage pneumatic rig builds?
Forged metal manifolds keep your shop air steady while dodging rust from wet compressed lines.
- Dense bronze cores stop gritty particles from scoring up weak plastic alternatives after a few seasons.
- Tight barb design anchors standard vinyl pipes to kill annoying drop in pump pressure.
- Thick copper alloy walls absorb engine vibrations so your quick connect valves never crack loose.
✝️