Hella Tough 2 Inch Narrow Weld On Johnny Joint Rod End For Shop Built Suspension Wrenching And Hot Rod Fabrication Externally Greased Heavy Duty Street Ready Performance Setup

Heavy Duty Narrow Weld On Johnny Joint Rod End Unit
✔️ 2 inch OD unit with 1.600 mounting width and grease fitting

This single precision rod end helps you weld control arms and dragster rear links at home. You get smooth articulation for weekend cruise nights and strip runs. The threaded mounting holes align with standard hardware so your fabrication stays quick.

✅ Heat treated steel cup handles torque loads without spinning inside the welded dome
✅ High density urethane bushing absorbs pavement chatter before it hits your steering wheel
✅ Externally mounted zerk port keeps your workspace clean while you pump fresh grease

💡 What makes a shop built suspension node really handy for hot rod fabricators?
You stay ahead of wear gaps when the reinforced shell takes impact without flexing.

- Cross drilled cores take lubricant fast so your linkage stays smooth under hard impacts.
- Wide travel angles clear bump stops easily while keeping chassis geometry tight.
- Easy threading keeps your tie rods level while you dial in toe settings.

✝️