Heavy Duty Swivel Rocker Chair Mechanism With Steel Spring Plate Base And Complete Fastener Kit For A Dead Nuts Solid Setup And No Sweat Installation To Keep Things Rolling Slick
✔️ Steel swivel mechanism, 190x190x76mm, complete bolt kit
This heavy duty swivel rocker chair mechanism acts as a direct replacement part designed to restore smooth rotation and rocking motion to bar stools, boat seating, commercial chairs, and workshop furniture. Built for daily wear, it swaps out worn out bases without messy welding, making it a handy update for local contractors and weekend builders.
✅ Black powder coated steel frame measures 190 D x 190 W x 76 H mm alongside traditional 7.5 D x 7.5 W x 3 H inch measurements✅ Four internal coil springs absorb impact stress for steady rocking over rough terrain
✅ Includes eight M6 x 30 mm bugle head screws along with matching nuts and washers for immediate mounting
✅ Heavy design handles up to seven pounds of hardware weight while resisting corrosion on outdoor decks
💡 How do you properly align mounting holes when installing a steel swivel rocker chair base to prevent gear binding? Tighten the hex mounting hardware gradually in opposite corners to balance load distribution across the support plate. - Apply moderate force to seat the spring tension before final tightening prevents gear binding later - Measure twice to guarantee clearance from nearby legs so the pivot point stays unobstructed during full rock cycles - Keep the cross hole alignment level to reduce side load friction on the central shaft over time
✝️