Heavy Duty Stainless Steel License Plate Screws Complete Mounting Kit For Front Rear Car Plates With Sleek Carbon Covers Bolts Nuts Washers Phillips Screwdriver No Sweat Install Tight Fit
✔️Rustproof M6 hardware set includes carbon caps and driver
This single complete mounting kit supplies every fastener needed to attach front and rear vehicle registration plates. Mechanics and weekend wrenchers rely on this handy arrangement when swapping faded tags or upgrading rusty original equipment. The layout handles standard sedan frames and truck bumpers without extra trips to the parts counter.
✅ Includes four machine bolts and four self drilling screws sized 6 mm by 20 mm long (which matches 1/4 inch by 3/4 inch)✅ Built from mill grade stainless steel that ignores road salt and seasonal humidity without peeling
✅ Packs eight textured polymer covers that slide right over exposed shafts for a slick finished look
✅ Arrives ready to go with a compound screwdriver plus soft foam rings to kill plate rattle on bad roads
💡 What threading standards do professionals trust most when bolting down lightweight aluminum registration plates?
- Chase coarse metric pitches deep into stamped zinc panels so the cross threads grab hard and last
- Skip electroplated finishes on exterior faces since bare grain conducts cold and sheds water faster
- Dial in hand torque until the washer sits flush to keep the bracket square and avoid warping the frame mount
- Lock everything down with polyamide insert nuts so your setup stays tight through muddy season and desert heat