Heavy Duty Sheet Metal Dimple Die Set With Five Carbon Steel Punches And Nylon Backing Discs Built To Fit Harbor Hydraulic Drivers For Crafting Clean Raised Dimples Fast On Any Badass Rig Or Home Shop

Five Piece Dimple Forming Kit For Raised Sheet Metal Edge Tabs
✔️ five carbon steel punches nylon backup discs fit standard drives

This handy dimple stamp setup pairs hardened steel drivers with tough nylon molds to knock out smooth, reinforced holes on thin aluminum and mild steel panels. Built to drop straight onto standard portable hydraulic wrench stations, mechanics and fabricators can pull tight bead lines or decorative flares on the shop floor without juggling extra adapters or wasting time hunting down special machine orders.

✅ High grade carbon steel punches maintain sharp contours during repeated compression cycles
✅ Reinforced nylon die inserts absorb impact shock while shaping clean radial ridges
✅ Flat backed steel support plates clamp down firm to stop lateral movement during draws
✅ Open slot design accepts common aftermarket cylinder heads for fast swap jobs on compact rigs

💡 Why do recessed button edges tear or rip when operating cheap stamping tools?
A successful dimple run relies on matching punch geometry to backing plate clearance so hydraulic squeeze distributes weight evenly across loose sheet metal blanks.
- Align the steel driver tip dead center inside the nylon cup to keep ram force balanced throughout the thick carbon steel contact zone
- Lock the flat support ring flush against the workpiece face to eliminate wobble while the curved mold pulls thin stock upward
- Cut away fresh burrs prior to loading frames so mating surfaces seal flush during heavy press strokes without gouging soft alloys

✝️