Heavy Duty New Hydraulic Power Unit Motor For Snow Plows And Liftgates No Sweat Swap Direct Oem Replacement Runs Smooth Built Legit Tough For Commercial Trucks And Heavy Equipment

Reliable 12V hydraulic motor for snow plow liftgate systems
✔️ Single replacement unit, 12V dc, 1.6kw rating, tang shaft 6.5mm x15mm

A compact pump driver designed to run liftgate cylinders and snow plow rams on commercial rigs. This listing includes a fresh single motor ready for immediate installation. Drop it into place of worn factory parts to get clean fluid flow and steady push cycles for daily hauling or winter road work.

✅ Tang shaft measuring 0.256 inch or 6.5 mm wide for secure alignment
✅ Stator housing spanning 4.5 inch or 114.3 mm for standard bolt patterns
✅ 5 slash16 24 threaded studs for direct power panel mating
✅ Full 12V system operation rated at 1.6 kw output capacity
✅ Seal ring sized to 0.591 inch or 15 mm outer diameter for leak free sealing

💡 What keeps a heavy duty auxiliary hydraulic drive motor reliable through hard season shifts
Picking the right replacement unit basically comes down to matching electrical draw and mounting geometry before you toss it in your rig.
- Line up the handy 6.5 mm slide width to lock the rotor snug against your pump casing
- Check the 15 mm outside dimension to clear your bracket hole without any extra drilling
- Hook the solid copper posts directly into the solenoid block for steady current feed
- Trust the sealed ball bearing stack to kill off vibration when pushing cold fluid