Heavy Duty High Temperature Sump Pump 1/3 Hp 208 Volt Single Phase With 2 Inch Npt Discharge And 70 Gpm Flow Featuring Corrosion Resistant Stainless Shaft And Non Clog Impeller For Trouble Free Hot Water Extraction

Reliable Single Unit Hot Water Extraction Pump 1 3 HP 208V
✔️ Single phase motor, 2 inch discharge, corrosion resistant

This single pumping assembly shifts scalding fluids up to two hundred degrees Fahrenheit straight out of tight basins. You will usually drop it into commercial boiler blowdown lines or heavy manufacturing tanks where standard submersibles fry instantly.

✅ Sealed 300 series stainless steel shaft resists heavy corrosion
✅ Semi open impeller clears debris plus solid chunks effortlessly
✅ Built thermal overload cuts power when things get too hot
✅ Pre wired severe duty power cable handles continuous submersion

💡 Can a heavy duty hot water extraction pump survive continuous boiling loads without shorting out?

Pulling scalding runoff out of commercial boilers stays super handy when you avoid premature motor replacement.

- The sealed copper windings run cooler thanks to direct fluid cooling channels surrounding the rotor

- Ceramic mechanical faces grind less and stop leaks even when sludge enters housing

- Capacitor kick starter pushes startup torque way past typical jammed drain models

✝️