Heavy Duty Front Drive Shaft Support Bracket For Dodge W200 W250 W300 W350 Direct Replacement Rock Solid Center Hanger And Bushing Assembly Built Tough Transmission Transfer Case Support Rig For 1975 Through 1993 Vehicles

Heavy Duty Center Bearing Hanger Kit For Dodge Rams
✔️ Part 659318 mounts front shaft at 24.75 inches and 628 mm pack 1

This front driveshaft support bracket acts as a sturdy center hanger and bushing assembly designed to secure your drivetrain in place. Mechanics and daily drivers install it on older Dodge pickup models to eliminate vibration and keep the transfer case mounted tight under heavy loads or rough trail conditions.

✅ Direct fit replacement for factory front mounting locations
✅ Compatible with manual and three speed automatic setups
✅ Single steel bracket arrives with fresh grease packed bushings
✅ Engineered for twenty four point seven five inch driveshaft spans
✅ Swaps straight in replacing OEM part number 659318 easily

💡 What causes premature wear on truck transfer case mounts? Vibration ruins bearings fast when old brackets sag or crack under heavy highway miles. Swapping in a fresh center hinge setup is a pretty handy way to stop driveline shake dead in its tracks. - Stiff steel supports lock the front shaft angle and cut down on fatigue cracks - New rubber isolators take the pounding off chassis rails during steep climbs - Direct bolt action aligns transmission output smoothly with rear axle rotation Catch loose mounting hardware early and save cash on expensive drivetrain labor.

✝️