Heavy Duty Electric Hydraulic Hose Crimping Machine Workhorse With Ten Interchangeable Dies For One Quarter To Two Inch Steel And Oil Pipes Totally Rock Solid Forged Head Three No Fuss Operation Modes 220 Volt 3 Phase Shop Ready Power
✔️ Forged steel ramhandle manual automatic foot switch 220 volt
This electric hydraulic hose crimper tightens fittings on steel and copper tubing for automotive shops, industrial repair bays, and fluid power systems. It handles fuel lines, brake hoses, air conditioning coils, and water supply tubes without bending or leaking.
✅ Forged steel ram handle built for high pressure cycles✅ Adjustable nose plate clicks flush for precise die alignment
✅ Ten magnetic inserts cover one quarter to two inch tube ranges
✅ Three control switches let mechanics pick hand foot or auto mode
✅ Hardwired three phase motor pulls steady current from shop panels
💡 What factors keep die alignment dead straight when pressing different gauge oil lines?
Getting consistent bead size comes down to stiff hydraulic flow and tight die clearance.
- A cast iron pump chamber pushes clean PSI straight into the forged ram without heat bleed
- Magnetic die holders grip the cylinder wall firmly so switching from quarter stock to two inch rail takes seconds
- Hook up the handy foot switch circuit when you want steady cycle times while keeping fingers clear of pinch zones
- Set the adjustable nose stop until it kisses the die face and mark the position for tomorrow’s batch run