Heavy Duty Driveshaft Tube Yoke Replacement For 1350 Series U Joint With 3.000 Inch Tube Size And.083 Wall Thickness Hot Welded Upgrade Smack It Straight On Dead On Alignment Killer Durability Long Term

Heavy duty driveshaft yoke single piece for trucks
✔️ 3.000 inch tube,.083 wall thickness welded housing

This replacement weld yoke snaps directly onto your front or rear driveshaft assembly to replace worn factory components. It mates flawlessly with standard 1350 series cv shafts and custom builds that require heavy duty alignment and smooth power transfer under load. The heavy gauge steel resists fatigue from constant spinning cycles, making it a smart choice for daily drivers and work trucks alike.

✅ Matches OEM part numbers P3-28-57, N3-28-57, and 3-28-57 for easy swap out
✅ Measures 3.625 inch wide with a 1.188 inch bearing cap diameter
✅ Holds 20 degree joint angle with an outside snap ring retention system
✅ Features a 2.000 inch center line to weld point and 2.845 inch butt diameter

💡 What are the main advantages of a welded driveshaft yoke?
Building a custom or off road rig requires parts that stay true under heavy stress. Swapping to this setup is a real handy move that saves labor and boosts longevity. Check these practical benefits:
- Straight cut ends mate directly with 3.000 inch tube sizes for zero wobble
- Thick wall housing absorbs torque spikes while keeping joints sealed tight
- Standard snap ring grooves accept any compatible kit for quick shop swaps