Heavy Duty Carbon Steel M12 Spring Plunger Acting As A Smooth Operator With Rock Solid Ball Nose Tip Total No Brainer For Industrial Machinery Setup Secure Clamping And Quick Workshop Positioning Tasks Every Single Day
✔️ M12 spring plunger with 6mm ball nose tip and steel lock nuts
This heavy duty carbon steel locating pin works as a reliable indexing and clamping tool for industrial machine setups and workshop fixtures. You install the threaded shaft into your equipment plate, tighten the included nuts, and push the knurled knob to extend the ball nose for firm mechanical hold. It handles repetitive positioning cycles without backing out under vibration or heavy loads.
✅ Thread size: M12 x 1.5 pitch for solid engagement in tapped holes✅ Thread length: 20 mm / 0.79 inches for deep mounting stability
✅ Pin body diameter: 6 mm / 0.24 inches with a hardened ball nose tip
✅ Carbon steel made with a black oxide coating against rust and scrapes
✅ Includes hex lock nuts to keep the assembly tight during high vibration runs
✅ Knurled operating knob provides fast one hand extension and retraction
💡 What makes a spring locator pin the handy selection for custom jigs?
To get accurate repeatability on the shop floor without swapping heavy hardware, you rely on internal compression coils that drive a polished carbide sphere into your workpiece.
- Delivers consistent tactile feedback when sliding matching parts into registered pockets
- Absorbs lateral shock loads so your fixture plates stay seated during cutting passes
- Runs clean and quiet thanks to sealed bearings preventing grit buildup over time
- Saves bench space since the compact design mounts inside narrow equipment frames