Heavy Duty Bearing And Seal Kit For Front Load Washer Tub Replaces W10772618 W10253864 Includes Three Bearings And One Seal Built Like A Tank Smooth Operation Fixes Any Model You Got

New front load washer bearing and seal replacement kit
✔️ Three shielded bearings and one reinforced rubber seal

This heavy duty kit swaps out the worn shaft rings that make your drum rattle and leak water across the floor. You drop it right into the tub housing to silence annoying mechanical noise and get that reliable spin cycle running smoothly again.

✅ Kit includes three sealed steel balls and one flexible lip membrane designed to block soap residue
✅ Exact cross reference match for replacement part numbers W10772618 and W10253864 across major brands
✅ Pre-greased design lets you slide it over the drive shaft without messy manual lubrication steps

💡 How do you troubleshoot loud grinding noises during the high speed extraction phase?

That harsh metallic racket usually means the rear bearing race got totally fried from too many soaking wet blankets.

- Clear out the drain pump filter first to rule out simple coin interference stopping the drum from turning freely - Grab a handy screwdriver set to pop off the rear access cover so you can spot check the belt alignment - Loosen the central drive hub nut with vice grips before pulling the inner basket forward off the splined post - Tap the new sealed sleeves straight into the cast iron flange using a flat hammer block to prevent future misalignment ✝️