Heavy Duty Auto Reset Limit Switch L180-20F Replaces 338096-701 For HVAC Furnace And Heat Pump Units A Solid No Hassle Upgrade That Keeps Your System Running Smooth Like Butter Any Day You Roll With It

Heavy Duty Limit Switch Pack Of One For Carrier Furnaces
✔️ Snap disc cuts power at 180F resets once cool to 160F

This pack of 1 L180-20F auto reset limit switch replaces OEM part 338096-701 and plugs right into most Carrier heat pump, furnace, and central air setups. It works as a dependable safety cutoff that trips whenever internal coils run too hot, giving DIY folks a slick upgrade to keep their rigs humming through freeze and thaw cycles.

✅ Swaps cleanly with Carrier codes 59SC5A060S171114 and PG95SAS42060BAAA
✅ Runs on a robust bimetal snap plate for instant thermal reaction
✅ Stops short cycling dead while saving cash on costly HVAC calls
✅ Clips onto standard brackets and hooks up fast without fancy gear

💡 What triggers an automatic limit switch to trip repeatedly on a residential furnace heat exchanger assembly?
If your home rig keeps tripping mid cycle, clogged filters or tight airflow are usually the culprit because trapped heat backs right up into the housing.
Tossing in a solid swap like this handy thermostat switch kills the heat surge fast without frying older parts.
Quick wire hooks snap everything back online so your blower runs steady again.
Just pull the old drain line, rinse the mesh pads, and your whole setup stays primed for another winter season.

✝️