Heavy Duty 3 Piece Floor Jack Replacement Screws For 3 Ton And 4 Ton Hydraulic Jacks Rock Solid Garage Gear Built Tough For Quick Car Fixes And Weekend Wrenching Projects

Heavy Duty 3-Pack Floor Jack Handle Screws for 3-Ton Lift
✔️ Zinc plated steel jack handle bolts measure 12x1.75 threads

This three piece set replaces worn out hardware on standard hydraulic floor jacks kept in home garages and mobile repair pits. The hardened steel fasteners secure the lift handle so you can safely raise vehicles during routine oil changes without deal breaking slippage.

✅ Hardened steel cores resist corrosion while holding fasteners down under heavy lifting pressure indoors
✅ Overall measurements sit at eighteen point eight mm and zero point seventy four inch tall alongside eighteen point five mm and zero point seventy three inch width
✅ Thread gauge lands at eleven point eight mm and zero point four six inch across paired with six point nine mm and zero point two seven inch shaft thickness
✅ Three piece kit ships already cut to exact specifications so swapping stripped parts takes minutes rather than hours

💡 What helps prevent loose gripping pins from sliding out while cranking up heavy ride height during monthly maintenance?

Finding correct replacement bolts is handy since weak hardware ruins leverage control when your axle hangs unsupported. You want steady performance by checking exact thread depth and picking upgraded metals that fight fatigue under constant strain.

- Standard metric alignment locks securely into designated holes without spinning free during rapid pump cycles

- Quench tempered steel bodies absorb impact shocks so your lift frame stays intact through seasonal weather swings

- Factory spec cutting saves cash versus ordering complete hydraulic stacks anytime minor fastener damage occurs

✝️