Heavy Duty 24V Electric Linear Actuator With Built In Hall Sensor And Four Piece Sync Control Kit Offering 150mm Stroke And 3000n Thrust For Ridiculously Sweet Diy Rig Builds That Totally Knocks Out Heavy Lifting Jobs Right Dead On

Reliable 24V Linear Actuator With Hall Sensor Kit
✔️ 150mm travel linear slide unit 3000n push force built hall sensor

This single 24 volt electric linear actuator pairs with a four piece sync control box to knock out heavy lifting jobs on workshop jigs, lift tables, or automated gates that need reliable torque without guessing.

✅ 150 millimeter stroke length delivers reliable extension and retraction cycles
✅ Sealed aluminum alloy housing protects against dust and moisture during outdoor jobs
✅ Permanent magnet DC motor runs smoothly at nine millimeters per second under full load
✅ Integrated hall encoder tracks exact rod position so your rig stays square every time

💡 How does a synced linear slide system handle heavy platform raises without drifting? This wiring trick keeps all four rods moving in perfect unison even when the weight shifts around.
- The hall effect chip outputs precise voltage pulses that map directly to armature movement
- A dedicated sync controller matches those signals and feeds equal power to every drive coil
- Tying into a handy parallel switch bank lets operators raise or lower stages with zero lag
- Tech shops rely on this gear because sealed bearings and brass worm gears stop friction from ruining alignment

✝️