Heavy Duty 2012 Taper Lock Bushing With 1 3/8 Inch Bore And Two Point Seven Five Inch Outer Diameter Engineered For Robust Industrial Drive Components Built Tough To Prevent Slippage Factory New Straight Up Replacement Fitment That Runs Flawless Under

Heavy duty 2012 tapered lock bushing for equipment drives
✔️ 1.375 bore, 2.75 outer dial, 1.25 depth, single piece

This factory new tapered locking bushing clamps down on rotating shafts for heavy equipment and power transmission setups. You will usually bolt it inside pulleys, sprockets, and couplings on conveyor frames, ag machines, and motor mounts where steady torque transfer keeps things rolling.

✅ Precision ground 1.375 inner opening mates with standard shaft specs
✅ Thick steel shell takes high RPM loads without flexing
✅ Handy quick clamp design stops belt slip on hard pulls
✅ Drop in replacement works with older drive layouts

💡 How do you properly seat a taper lock bushing for zero play?

- Clear the shaft groove and bore floor with carb cleaner so fresh metal meets metal tightly. Skip old rags that shed lint into the contact zone.

- Crank both mounting bolts in a figure eight pattern until the wedges bite solid. Back off light once you hear the torque click to save threads

- Line up timing dots right before you push the hub home. Break it in slow so you can tweak tracking before you hit full load on the belt path