Heavy Duty 1750W Magnetic Drill Beast Built To Slice Through Two Inch Hardened Steel At 810 Rpm While Delivering Rock Solid 2922 Pound Holding Force

Heavy Duty Magnetic Base Drill For Precision Hole Cutting
✔️ 1750W copper motor, 810 RPM, 50mm bore, 2922 lbs hold grip

This single magnetic core cutting unit handles heavy plate work and industrial maintenance routes with steady feedback. Designed for structural steel repair and bridge deck boring, it anchors securely to flat surfaces so crews can punch accurate apertures straight through two inch hardened steel without walk or slip. The sealed copper drive stays reliable through dust and oil exposure common on active job sites. Operators trust this build for continuous daily shifts where downtime kills profit margins.

✅ 1750W pure copper windings drive steady 810 RPM cutting speeds
✅ Maximum 50mm (1.97 inches) core diameter and 50mm (1.97 inches) depth reach
✅ Sliding ruler dial pins location marks down to the fraction of an inch
✅ Tri crank arm lever cuts wrist fatigue during transport and alignment
✅ Dual vent channels and thermal cutoff protect the drive under load

💡 Why is a magnetic core drill handy for heavy plate boring operations? Snag the proper rig when you need to slice thick gauge plate clean without wrecking your back on manual setups.
- Strong electromagnetic base locks onto flat surfaces without external clamps
- High torque output cuts through two inch harden steel without stalling
- Integrated depth stops and ruler markings prevent messy overcutting
- Copper windings and forced air cooling extend service life on shift work