Heavy Duty 10S 36V 35A BMS Protection Board For LiFePO4 Battery Packs With Kickass No Fuss Wiring And Built In Smart Balancing Heatsink Ready For Custom Projects

10S LiFePO4 Protection Board For Custom Power Modules
✔️ 35A continuous current rating with integrated heat sink cooling

This single packaged battery management system locks out rapid failure damage while shielding lithium cells from overcharging and deep draining. Builders install it inside electric bikes, mobile work stations, or backyard solar banks where steady voltage reading stops surprise power drops dead in their tracks.

✅ Ten low resistance MOSFET transistors handle peak surge loads near one hundred amps safely
✅ Reads real time temperature data to trip circuit breakers before overheating sets in
✅ Sized at sixty nine by fifty one point five by ten millimeters (two point seven one by two point zero two by zero point three nine inches) stacks compactly inside standard control boxes

💡 What protects lithium cells from voltage imbalance and sudden current spikes?
This handy setup runs quiet background checks on every cell pair so your bank handles daily charging routines and heavy power pulls without risk.
- Stops early degradation by locking steady voltage splits across all individual nodes
- Cuts power instantly when severe short circuits or weird current spikes show up
- Keeps temps low with direct thermal transfer pads that dump waste heat straight into the outer shell