Heavy Duty 1 Inch ID Two Piece Locking Shaft Collar Made From Tough Steel With Classic Black Finish And Rock Solid Grip For No Fuss Machine Assembly And Long Term Shop Floor Performance

Rugged steel locking collar for precise industrial machine setup
✔️ One inch inside diameter black oxide split locking ring unit

This single heavy duty locking collar keeps rotating hardware tight on cylindrical drive shafts. Maintenance crews and fabrication shops use it to lock in correct positions for motors, pulleys, and sensor brackets during heavy operation cycles.

✅ Two piece split ring allows fast on shaft adjustment
✅ Black oxide coating fights shop floor corrosion
✅ Standard hex bolts deliver even clamping pressure
✅ One inch nominal bore fits standard round stock
✅ Single unit ships ready for immediate machine assembly

💡 What makes a two piece locking shaft collar superior to solid split rings on industrial drive trains?
You get better positioning accuracy when upgrading your bearing support systems.
- Fine tuning an adjustable collar cuts installation time by letting techs shift alignment marks without removing hardware
- Dual half clamp geometry spreads mounting pressure across one inch bores for consistent rotational stability
- Torquing standard hex fasteners locks down flat ground contact surfaces against square or round rod stock
- Workshop crews trust this handy configuration for maintaining exact centerline distances on heavy duty pulley assemblies